|
Disclaimer:All the content of project has been submitted by the author, so if you get any inconvenience by making this project, The NewCircuits team will not be responsible. It means the submitted project is "as is". Also If you have any question about the project, you should contact the author by email.
2 LED Flasher
Click to enlarge
This is a 2 LED flashing circuit. It is based on an analog flip flop circuit.
This particular circuit was calculated to use blue or white 3V LED with a 12V
power supply. If you are using red green or yellow LED, replace the 1K resistors
for a 2.2K.
This circuit will flash the led at a 1 sec interval in alternance. For faster or slower
flashing speed, you can increase or decrease the 100K resistors.
 
Submitted by: Richard Marier
Would you like to discuss about it?
Leave a post in the forum.
| 
